Don't fail because I dig the inside of the ditch!
A sheet-type striped guide tape is on the market!
GUNPRIMER Panel Line Guide 1 (Straight Line)
Composition: 3 sheet / 100 pieces
Size variant:
0.1mm Width
0.2mm width
0.3mm Width
※ Beginner to Intermediate
A sheet type set of streaking guide tapes.
The Panel Line Guide 1 series is mainly designed for new creators.
This straight line guide is designed to carve the central groove of each guide tape to prevent overruns (failure to carve to excess) and line breaks.
Also, it is a little more soft than the various types of stripe-cutting guide tapes, and even if it is slightly curved, it does not leave any glue when peeling. There are three sheets per product. each sheet (1) Strain length 1 mm to 30 mm, total 60 sheets (2) Strain length 31mm to 40mm, total 20 sheets (3) Strain length 41 mm to 50 mm total 20 sheets A total of 100 stripe-cutting guide tapes are included.
Each guide tape also has an angled guideline that allows you to draw various guidelines freely.
*One guide seal can be used several times if it is not heavily stained, dust, oil, etc.
Also, please remove the streaked dust with a clean brush immediately after it gets dirty.
[Notice]
※ Please take off the oil and dust on the surface to be pasted before pasting.Also, be careful not to touch the adhesive surface as much as possible when you touch it with your fingertips.
*For engraving, we recommend using it in combination with various other engraving tools.
Comentarios